![]() ![]() Fiber-to-fiber media converters are normally protocol independent and available for Ethernet, and TDM applications.Įnterprise networks often require conversion from MM to SM fiber, which supports longer distances than MM fiber. In addition, they support conversion from one wavelength to another. They can automatically detect the signal baud rate of the connected Full-Duplex serial device, and support point-to-point and multi-point configurations.įiber-to-fiber media converters can provide connectivity between multi-mode (MM) and single-mode (SM) fiber, between different power fiber sources and between dual fiber and single-fiber. Serial-to-fiber converters provide fiber extension for serial protocol copper connections. ![]() T3/E3 and T1/E1 converters usually operate in pairs extending distances of TDM circuits over fiber, improving noise immunity, quality of service, intrusion protection and network security. The most common TDM copper-to-fiber converters are T1/E1 and T3/E3 converters, which provide a reliable and cost-effective method to extend traditional TDM (Time Division Multiplexing) telecom protocols copper connections using fiber optic cabling. The diagram below shows a typical application where Ethernet Media Converters connect to Ethernet Switches by way of Multimode fiber and UTP copper cabling. Hence these converters are also usually divided into Ethernet media converter, Gigabit media converter and 10 Gigabit media converter. Supporting the IEEE 802.3 standard, Ethernet copper-to-fiber media converters are used to provide connectivity for Ethernet, Fast Ethernet, Gigabit and 10 Gigabit Ethernet devices.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |